SEATS 1H 15 Cables are installed to proper gem nuts and hgyi 5 To install reverse removal procedure Make zontal actuator as shown in Figure 1H10 sure seat harness is properly secured to seat See Fig 1H11 FRONT SEAT ADJUSTER TRANSMISSION FULL WIDTH ELECTRIC SIX WAY TILT Disassembly and Assembly Rem v I nd l s lI i 1 Remove front seat adjuster transmission from seat assembly 1 Remove front seat assembly from body with attached adjusters motor and transmission and 2 Remove screws securing gear housing to the place upside down on a clean protected surface solenoid housing then carefully separate housings and remove component parts of transmission as 2 Disconnect wire harness connector from sembly Fig 11115 transmission See Fig 1H11 3 To assemble transmission reverse removal 3 Remove screws securing horizontal and V l t1 procedure cal cable end plate on both sides of transmission and detach cables from transmission IMPORTANT Prior to or during installation 4 Remove transmission to support attaching lubricate frictional surfaces of driving gear bolts then disengage transmission from motor thrust washer large gears dog washers gear drive coupling and remove transmission from seat shafts and solenoid plungers with Lubrip1ate assembly GBOAAW or equivalent