I Replacement 1 Using a pointed tool such as Tool J 7777 raisf one end of the weatherstrip retainer until it is fa enough out to take hold of by hand Then pul retainer out of its channel all around the window 2 From inside the cab carefully push the windov glass out through the rear of the opening NOTE The weatherstrip may remain in the window opening during removal of glass To remove weatherstrip merely pull it off the edges of the body panels On installation of new weatherstrip dean panel opening edge thoroughly then install with butt ends lightly coated with weatherstrip adhesive at top center of opening 3 Inspect the cab inner and outer flange making sur they are true and that there are no irregularitie around the opening Any irregularities must b corrected 4 Assemble the weatherstrip to the opening makin sure the outer channel of weatherstrip is firml seated on the edges of the panel all around th opening 5 Start one end of the glass into its channel in th weatherstrip Using a pointed tool follow aroun the rear lip of the glass channel so it bears again the rear surface of the glass fig 10 24a NOTE Care should be used in this operation not to chip the edge of the glass A pointed wooden tool if available should be used I Fig 10 24a Installing Cab Rear Glass Typical 6 Feed one end of the weatherstrip retainer into tl handle of Tool J 2189 fig 10 25a and out throu the end which spreads the weatherstrip chann 7 Starting at the bottom center insert the end of tl tool and end of retainer in channel tapered pa of the retainer toward the glass 8 While holding the tool firmly with spreading ei in channel follow around the channel spreadii r 1 1 1 o v r s r